Travertine restoration

Travertine naturally contains voids that are filled at the factory. Traffic and cleaning wear that fill away over time, exposing holes that trap dirt and water. Re-filling and honing restores a flat, closed surface.

We deep clean the stone and grout, fill open holes with a colour-matched filler, then hone the surface flat with diamond pads. The floor is finished honed or polished to your choice and sealed with an impregnating sealer.

Honed suits most homes and wet areas because it hides wear and is less slippery. Polished travertine gives a brighter, more formal look in hallways and reception rooms. We can show you both on a test area.

A bathroom or kitchen usually takes one to two days; larger ground floors with many open holes can take three days or more because the filler needs time to cure before honing. We confirm the timeframe in the quote.

The work area needs to be clear of loose furniture, though fitted units stay in place. Honing is done wet with slurry collected as we go, so there is very little airborne dust. Patio work is planned around dry weather.

Use a pH-neutral cleaner, avoid acidic or bleach-based products, and re-seal every few years in busy areas. Projects under 100 m² are priced per job; projects over 100 m² are priced per m², and you get a fixed written quote after a free assessment.